Giclee Foam Roller

Hints on Applying Post-Print Coatings:- Stir the laminate well before use. Be careful not to shake the laminate as this will cause it to bubble. Pour only the amount of laminate you intend using into a clean receptacle. Saturate the roller with EternaCryl laminate. Remove excess fluid by rolling out on a smooth surface. Rough or irregular lines in a “paint tray” could transfer from the roller to the image. Apply your first coat in one direction (north/south) only, and if a second coat is required then apply in the opposite direction (east/west). If applying more than one coat, allow first coat sufficient time to dry. If applied correctly, the laminate will find its own even level. The result should be a post-print coating that is visually pleasing, offering you the highest level of protection against scuffing and scratching. In our opinion, two light coats of lamination yields a visually more pleasing finish than one, saturated coat.